link to ats electrolube europe's linkedin pagelink to facebook page for ats electrolube europelink to youtube channel for ats electrolube europelink to twitter page for ats electrolube europe


about ATS

contact us


get quote

link to ats electrolube europe homepage

Lubricator Brackets

ATS mounting plates and brackets for automatic lubricators make mounting your system a snap. They can be either screwed in, or simply hung with a bolting clamp.

Fit ATS lubricator brackets directly to machinery, to the wall or ceiling. Our powerful lubricators can all be mounted in any orientation, even upside down, up to 10m from the lube point. 

Our multi point lubrication system brackets feature a built in distribution block, allowing you to feed up to 12 points from a single lubricator – providing the most cost-efficient system available. 

All of our lubricator brackets allow for the fitting of a lubricator weather cap. This provides secondary protection in particularly dusty, steamy, or wet environments.

link to related article on remote mounting lubrication

remote mounting lubrication systems

image of two electro lubes mounted remotely

How to fit automatic lubricators

ATS Electro-lube Europe logo and image of automatic singe point lubricator
Bracket banner for ats electrolube lubricators

Lubricator Brackets

Fitting lubrication systems to rails

If there are rails, posts, screens, or fences near to the lubrication point, then the easiest way to fit a lubricator is to simply hang the bracket with our fixing bolt kit.

As shown in the top image, the c-shaped clamps bolt around any rail or upright in a few seconds.

The luber then simply slips down into the bracket from above, is secured with the retaining ring, and then turned on as per the lubricator instructions.

Fitting lubrication systems to the wall

To fit any ATS lubrication system to a wall or ceiling, hold the bracket up against the surface, and with a pencil mark the location of two of the fixing holes. 

Take the bracket away, drill the marked holes, and put a wall plug in each hole. Then put the bracket back up to the holes and use suitable screws to fix it. 

Slip the lubricator into the bracket, secure with retaining ring, and set the lubricator as per the instructions.

find a distributor

Automatic Lubricators

Lubricator Accessories




multi-p‍‍‍oint lubricator bracket

Ulitmate automatic lubricator mounted in multi-point lubricator bracket, with grease distribution block fitted to underside of bracket